Common problems and countermeasures of can filling machine

Common problems and countermeasures of can filling machine

It is a common thing to encounter problems during the use of the can filling machine. How to solve some problems is the key point. In fact, most of the failure problems in the use of the can filling machine are due to mistakes. It is caused by the operation and use method, so the can filling machine must strictly follow the operation and use specifications in the actual operation and use, and continue to accumulate operation and use experience, so as to quickly solve some fault problems of the filling machine!

Common problems and countermeasures of can filling machine:

1. The filling volume of the can filling machine is inaccurate: when filling large-scale materials, the feeding tank is lacking, resulting in an unstable liquid level.

2. After adjusting the digital dial or unit, the time will not change. Treatment method: At this time, turn off the power and turn it on again.

3. The liquid level is stable and the filling amount is incorrect: there is debris blocking the filling channel, which is mainly at the entrance of the trough or in the filling mouth. Treatment method: Check and clean.

4. There are drips after closing:

1. It may be that the orifice of the filling nozzle is damaged. Treatment method: The filling nozzle can be taken out to trim the orifice, and the diameter of the orifice cannot be greater than 7.5mm. After repairing the aperture, slightly smooth the aperture on the water-grinding paper.

2. It may be that the ball valve in the filling head is damaged. Treatment method: The ball valve needs to be replaced.

5. No feeding after touching the feeding switch, and the digital guidance LED of the time relay does not flash. Treatment method: The injection switch is damaged or the time relay base is loose, replace the injection switch of the same type or press the time relay base tightly.

6. After touching the filling switch, the digital LED indicator light of the time relay flashes, but if the filling is not filled, if the taste is well maintained, the common faults of the can filling machine will not be common, so maintenance is the key.

When there are some common failure problems in the can filling machine, it is first necessary to conduct a comprehensive inspection of the existing problems of the equipment. Because the interior of the filling machine equipment is relatively complex, it is not recommended to disassemble and repair by yourself if there is a failure problem. Only maintenance technicians can carry out maintenance and replacement, so as to solve some common failure problems of can filling machines!